> Then, when I try to hard code in new PR2/precale values for a 5 KHz, and
> reactive the PWM, the frequency will still remain at 20 KHz regard of
> all logical efforts to clear it.  Now, I have also read carefully the
> section on the timer 2 module.  I am anywhere of how the timer2 module
> operates also.  Now, I have found this must out.  If I only change the
> value of PR2 to change frequency, then the frequency actually changes.
> However, trying to change the timer2 prescale to change the PWM
> frequency does not work at all.  Hence I believe the problem lives with
> the prescale double buffering.  However, the datasheets does not mention
> how to a situation like this.  When I change my frequencies, I must not
> only change the PR2 register, but also the prescale to achieve my newly
> commanded frequency.
>
> Like I have mentioned, I have narrowed the problem down to the
> prescaler.
>
> Any more input is welcomed.

Yes, I have more to say, but as I said in the previous message (and you
even copied):

> First, please remove you REPLY address so that a default reply goes to
> the
> list, not just you.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body