Is there a way to save couple of bytes (8 or 10 bytes) to eeprom just =
before power outage?

* I am using MPLAB C18 (the software is in C)
* The unit is working with 220V AC converted to 12V DC then 5V DC.
* Configuration bit is set so power on reset on, brown out detection on, =
brown out voltage 4.2, oscillator H4 (10MHz xtal working at 40MHz).

I looked up the datasheet, according to page 27, I checked the RCON =
registers POR bit (that is the only one affected with brown out for some =
reason) and saved 8 bytes to eeprom if the POR bit was 1.  I did this at =
the very first thing in the main() procedure.  However, it did not work. =
 Any ideas?

If anyone is interested the product can be seen at: =
http://www.teksan.com.tr/vana.asp?L=3DE&Id=3D0401
or goto http://www.teksan.com.tr, select product then bathcing =
solutions.

Thanks,

=D6mer YALHI
oyalhi@teksan.com.tr
http://www.teksan.com.tr/
Tel : +90 212 613 22 00
Fax: +90 212 544 70 35

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body