why not just use a sheet of writeright? this is its purpose.. andrew ----- Original Message ----- From: "Josh Koffman" To: Sent: Monday, December 16, 2002 8:46 PM Subject: Re: [OT]: Protecting a ScopeMeter Screen > Ah...I like this solution. Just a quick question about the scrubbing > part. How did you do it? I know that's a bit general so: Did you leave > it on it's backing sheet (if it has one)? What did you use to scrub it > with? I'd imagine something too rough will scuff the film up. Did you > just lay the sheet flat in the kitchen sink, or was it more vertical? > How did you know when it was all gone? > > Thanks! > > Josh > -- > A common mistake that people make when trying to design something > completely foolproof is to underestimate the ingenuity of complete > fools. > -Douglas Adams > > "M. Adam Davis" wrote: > > > > Go to your local office superstore (officemax, staples, etc). > > > > Find inkjet window cling media. It's the stuff you print on, then you > > can stick it (repeatedly, without losing adhesive) to glass and other > > surfaces. > > > > Take out one sheet. You find instructions on which side you're suppose > > to print on, and which side you're supposed to cling to the window. > > > > Using running water, scrub the side you're supposed to print on until > > you remove all the stuff the printer ink is suppose to stick to. It'll > > take some time, but the stuff is water soluable, and you'll end up with > > a crystal clear sheet of touchscreen protector. > > -- > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body