In Eagle 4.08r2:  when I set the width for a net class
to a certain value, it forces that class for the entire
net.  However, in some cases I don't need that much.  A
good example of this is the ground wire -- I set it to
90mil (few amps in many parts of the circuit), but some
parts of the circuit don't need 90mils, and this causes
a clearance problem with small, closely-spaced components
(the DRC complains about clearance).

Is there a way to solve this?

Thanks,
-Neil.

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body