Hi,

But where is Vcc and What is the DB15 connector? From my guess, I'm
connecting
the +V of the circuit to the 6th pin of the serial connector going to my
circuit together.
The sixth pin is the white cable, which goes to nothing in my circuit, and
the Vcc is pin 2.

I'm not sure if this is correct.
-Peter
----- Original Message -----
From: "Jan-Erik Soderholm" <jan-erik.soderholm@TELIA.COM>
To: <PICLIST@MITVMA.MIT.EDU>
Sent: Thursday, November 28, 2002 6:18 AM
Subject: Re: [PIC]: Wisp629


> >Hi,
> >
> >I was a bit confused by  which pins/points i should touch with the
> >led/resistor. Could you please tell me?
> >
> >-Peter
>
> This is from Wouter's Wisp628 page (the FAQ part) :
>
> - How can I check that the 16F628 in my Wisp628 is running?
>
>    Connect a LED and suitable series resistor (470 ohm) between Vcc and
>    pin 6 of the DB15 connector (LVP). Make sure the LED is in the right
>    direction (flat side with internal metal 'cup' towards pin 6). The LED
>    should flash two times very quickly when power is applied.
>
> Hard to be more specific than that...
>
> Jan-Erik Svderholm
> S:t Anna Data
> Sweden
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
>

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads