Hi group!

I've noticed that when using Wisp=2Eexe in terminal mode (term 1200 or
whatever), I get chars echoed even when nothing is connected to the port!

Tested on Win98SE so no need for port drivers=2E Even tried in true DOS-mode,
same behaviour=2E

Anyone experienced this?

/Hugo



-----Ursprungligt meddelande-----
Fr=E5n: petermcnulty@HOTMAIL=2ECOM [mailto:petermcnulty@HOTMAIL=2ECOM]
Skickat: den 27 november 2002 11:11
Till: PICLIST@MITVMA=2EMIT=2EEDU
=C4mne: [PIC] Wisp628


Hi,

I'm having a little problem actually communicating with the product=2E Using
the XWisp  Tool i use the command xwisp=2Epy com2 go led_1 (my filename)  then
it starts the process and i get:

    raise self=2EWBus_Protocol_Error, \
__main__=2EWBus_Protocol_Error: send=3D't' received=3D''

And nothing else happens=2E I did what it mentions on the site, and short
serial port pins 2 and 3 and type

xwisp=2Epy port com2 term 1200

It says try and type stuff, and if u see what you type then there is
communication between pins=2E Anyone got any ideas about this? I'm sure I'm
missing something small=2E

Also, I'm only  using a 10K resistor instead of the 33k  between + and MCLR
pin as i don't have any 33k resistors/ and combinations to make 33k or even
close=2E

Thanks
-Peter

--
http://www=2Epiclist=2Ecom hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma=2Emit=2Eedu

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu