Hi,

I'm having a little problem actually communicating with the product. =
Using the XWisp  Tool i use the command xwisp.py com2 go led_1 (my =
filename)  then it starts the process and i get:

    raise self.WBus_Protocol_Error, \
__main__.WBus_Protocol_Error: send=3D't' received=3D''

And nothing else happens. I did what it mentions on the site, and short =
serial port pins 2 and 3 and type

xwisp.py port com2 term 1200

It says try and type stuff, and if u see what you type then there is =
communication between pins. Anyone got any ideas about this? I'm sure =
I'm missing something small.

Also, I'm only  using a 10K resistor instead of the 33k  between + and =
MCLR pin as i don't have any 33k resistors/ and combinations to make 33k =
or even close.=20

Thanks
-Peter

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu