Would anyone have any input as to which power supply to get for an "El
Cheapo" Pic Programmer? The programmer is the one from "Programming an
Customizing PICmicro Mocrocontrollers", by Myke Predko (2nd ed.). I'm using
the board from the book, but I've changed a couple of the components per his
web site (http://www.myke.com/elcheapo.htm).

I've looked around quite a few stores in my area looking for a suitable
power supply, but no one carries anything over a 12 Volt (DC) power supply.

I've found some supplies from Jameco, listed below. I think the best one to
get would be the 15 Volt, 1000 mA regulated supply and the use some
resistors to get the current down. I just wanted to check first and see if
anyone had any direct experience supplying power to the board, or any
suggestions.

Voltage     Current (mA)
-------- ---------------
15    500
15    500
15    600
15    900
15   1000
15   1000
15   1000(regulated)
16    500

Thanks in advance for you help!


Jeff Polaski
jeffpolaski@cox.net

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu