I often use zero ohm resistors for the reasons listed. My question is: Zero
ohm resistors often come with a tolerance of +/-5% (digikey 311-0.0ACT-ND).
OK. What, then, is the device's range (especially on the minus side)?

Shawn


>From: Herbert Graf wrote:

> > I can't seem to figure out why.
>
>         Easier routing, allows probing of a signal that might be buried,
>allows
>adding a resistor later if needed. TTYL


_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
http://join.msn.com/?page=features/virus

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads