Hi-
I case you were not aware, there is several user forums at:
http://www.cadsoft.de/forum.htm where you can ask these questions to a
wider audience.  I suspect you can say NET XYZ on the command line and
then draw the net, and it will be connected.
David

Josh Koffman wrote:

> Ok, perhaps I phrased the question a bit badly. How about this. Other
> than drawing a connecting net between two other nets, and having that
> little window "Connect XXX to YYY?" pop up, is there a way to specify
> that two nets are to be connected?
>
> Josh
> --
> A common mistake that people make when trying to design something
> completely foolproof is to underestimate the ingenuity of complete
> fools.
>         -Douglas Adams
>
> Olin Lathrop wrote:
> > I don't know.  I make my own symbols.
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu

--
David Harris
  OmniPort Home Page:  http://www3.telus.net/OmniPort1/
    Discussion egroup: http://groups.yahoo.com/group/OmniPort
    Swiki:  http://omniport.swiki.net/1

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu