> Well, I've run into this problem. I am using a couple of chips from
> Cadsoft's library, and they don't show the power pins as they try to
> route them invisibly. Well, that's all well and good, but I don't have
> my power nets named the same as the chips do, so they won't get
> connected on the board. I could just add the traces manually on the
> board, but I want to try using the autorouter, and this will screw me
> up. Short of remaking the symbols, is there any way to connect the two
> nets?

I don't know.  I make my own symbols.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu