I'm looking for nearly the same thing but for a 30-volt, 15-amp
reverse capable PWM speed controller for brushed-DC permanent
magnet type motors. The +-30V is going to be supplied by a big
ni-cd pack.
I've looked around on the PIClist site and found some promising things
but they seem to lack reversability. Ideally, it'd be able to brake the
motors with a PWM-to-ground short circuit type mechanism instead of
trying to apply opposing voltage to get the motors to stop.

Maybe someone else has already done this exact thing. Gladly take any
suggestions!

Chris Loiacono wrote:
> Once again, I'm not looking for anyone to do my work for me - just
> hoping someone can give me a little push down the hill. I'm after the
> lowest cost way to make the 90V needed for a brush motor PWM speed
> control w/ current limit.....Any ideas as to where I might start
> looking?

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body