> Press-n-Peel comes in 8-1/2 by 11 inch sheets. Since none of my PCBs
> will be that large (Eagle freeware limit), I want to cut down the sheets
> so I can get more than one PCB out of a sheet. I figure I can attach it
> to a carrier sheet of paper to take it through the laser printer.
> Question is, how do I attach it? Is it safe to send tape or adhesives
> through the printer? Any other ideas?

I have used that stuff for years, it's the best!

I use computer labels to attach it to a piece of paper. Just along the top
edge, not all the way around the stuff.

Hint:
First I print on the paper, so I know where to put the blue stuff. But be
consistent where you input the paper, if you input through the
single-sheet feeder, do it that way first on the paper and then with your
sandwich, so the registration will be better.

Also, don't print too near the top of the paper, the printer's pickup
mechanism is more likely to hiccup on the extra layers there.

Cheers,

Bob

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body