I will print my PCB layout on the printer.  Then I cut a piece of Press N
Peel larger than that and tape it over the printed area on the sheet of
paper by placing scotch tape around the perimeter.  Then rerun it through
the printer.  Then I pull the tape off and iron it.  I measure the
temperature of the iron to make sure its in the recommended range and I have
found that it does a much better job.
Good luck,
Fred






>From: Josh Koffman <listsjosh@3MTMP.COM>
>Reply-To: pic microcontroller discussion list <PICLIST@MITVMA.MIT.EDU>
>To: PICLIST@MITVMA.MIT.EDU
>Subject: [OT]: Press-n-Peel PCB Transfer Film
>Date: Thu, 21 Nov 2002 01:30:19 -0600
>
>Hi all. I recently bought some Press-n-Peel Blue PCB transfer film
>(http://www.techniks.com/how_to.htm) from Peter Anderson. This is why I
>have been fighting lately with Eagle.
>
>Press-n-Peel comes in 8-1/2 by 11 inch sheets. Since none of my PCBs
>will be that large (Eagle freeware limit), I want to cut down the sheets
>so I can get more than one PCB out of a sheet. I figure I can attach it
>to a carrier sheet of paper to take it through the laser printer.
>Question is, how do I attach it? Is it safe to send tape or adhesives
>through the printer? Any other ideas?
>
>Thanks,
>
>Josh
>--
>A common mistake that people make when trying to design something
>completely foolproof is to underestimate the ingenuity of complete
>fools.
>         -Douglas Adams
>
>--
>http://www.piclist.com#nomail Going offline? Don't AutoReply us!
>email listserv@mitvma.mit.edu with SET PICList DIGEST in the body


_________________________________________________________________
Add photos to your e-mail with MSN 8. Get 2 months FREE*.
http://join.msn.com/?page=features/featuredemail

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body