Aha, I will try this directly after lunch. Thank you Olin. I have been
trying my best with Eagle. It's somewhat confusing, but I think I have
been doing ok working through the tutorial and just drawing schematics.
The big question will be whether or not I can then generate boards from
them. I'm quite sure I'm missing something simple in the way the various
power and ground nets are supposed to connect together on the board, but
don't need to be physically connected with a net on the schematic.

Josh
--
A common mistake that people make when trying to design something
completely foolproof is to underestimate the ingenuity of complete
fools.
        -Douglas Adams

Olin Lathrop wrote:
> Eagle uses misleading names for some commands.  You copy with the CUT
> command, which leaves the original there.  And the WIRE command draws
> lines, except when they are wires, in which case you use the NET command.

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics