Do you normally cut with copper up or down? I don't use photosensitive
boards.

Josh
--
A common mistake that people make when trying to design something
completely foolproof is to underestimate the ingenuity of complete
fools.
        -Douglas Adams

"Rick C." wrote:
> It's best to use a continuous firm motion, holding the handle with pressure
> toward the inside. Sometimes the cut will tend to drift on a curve and the
> board will start to twist. Compensate by rotating the board in the opposite
> direction of the curve. Hammering the handle with your fist will cause the
> cut to drift and possibly get away from you. Watch your fingers too! If

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu