I got a quote from a boardhouse the other day.
It was for a 18x33mm board.

They offered to prototype it on a single panel with 200 copies.
As long as we would accept about 1-2% crossouts...

We would pay about 450$ everything included.

That ain't too bad is it ?

    Kyrre

----- Original Message -----
From: "William Chops Westfield" <billw@CISCO.COM>
To: <PICLIST@MITVMA.MIT.EDU>
Sent: Wednesday, November 13, 2002 12:45 AM
Subject: Re: [EE]: Printer to PCB?


>     Doesn't sending your boards to Advanced Circuits or PCB Express sound
>     pretty good by now?  It's been entertaining watching the each flaky
idea
>     trump the next on this thread, but it's getting a bit rediculous now.
>
> Heh.  Which vendors WILL step&repeat a small board across some larger
panel
> as part of their low-cost prototype option?  Most of them seem to
explicitly
> prohibit this, some with language that sounds like it prohibtis YOU from
> doing it too...
>
> Thanks
> Bill W
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
>
>
>

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu