Is it too late for the software to measure the incoming baud rate (periodically ?) & adjust as required? RP We're talking about 2-4000 units so I'm a little nervous. It's not as much cutting production cost, as it is board space / layout... Because of some restraints I can only use single sided... This is what makes the layout a challenge. Kyrre ----- Original Message ----- From: "Josh Koffman" To: Sent: Friday, November 08, 2002 3:52 AM Subject: Re: [PIC]: How is the stability of the 16F628's internaloscillator ? > I agree, it isn't so bad, the problem is that you can never be > absolutely sure it will work from chip to chip. On a one off for > personal use it may be fine, but there are many that would refuse to put > such a device on the market. > > Josh > -- > A common mistake that people make when trying to design something > completely foolproof is to underestimate the ingenuity of complete > fools. > -Douglas Adams > > Kyrre Aalerud wrote: > > That wasn't so bad? > > > > Another chip gave me 1024 at normal temp... > > They ar probably from same batch, but it seems very good :-) > > -- > http://www.piclist.com hint: To leave the PICList > mailto:piclist-unsubscribe-request@mitvma.mit.edu > > > -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu