Roman,

here is the info on a supposed printer designed for PCB making.

The information is from the New Products section of the June=
 edition
of Nuts & Volts magazine

MCU Electrostatic PCB Maker

Will take output from most EDA software and Front Panel design=
 s/w
such as Autocad trace widths down to 0.006" (note Inches )=
 precision
is to 1200dpi.

The blurb then gets confusing as it waffles on aboutcorrect=
 pressure
and heat application.

The magazine has a photo of the printer

Contact : Charles Liu , 9300 Flair Drive, 106, Dept.NV, El Monte,=
 CA
91731

Fax: 626-287-7607    email: charlesliu_88@yahoo.com

I though of enquiring about its use for prototyping, but was put=
 off
by no website and a yahoo email address.

Colin
--
cdb, bodgy1@optusnet.com.au on 06/11/2002

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.