> Hi Cristian, how did you get the PCB to pass
> through the printer? Will it work with very small
> PCB's like 1" square??

Citizen used to make a flat bed ink jet printer about 10 years ago. Would
have been ideal for this use. Unfortunately I cannot remember the model
number.

It also had this other idiosyncrasy that you could print "normal way up" for
doing long print jobs which would go over many pages, or it could print
"upside down" in which case it would feed to the top of the page, and then
print down as you viewed the printout. Designed to be used for tear off
invoices at a counter. Come to think of it, this must mean it was a normal
dot matrix print head rather than inkjet, because it would do multipart
paper :)))) Just needed a ribbon with water resistant ink (not) :)))

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics