> Thanks Olin, I checked options>set>DRC but
> still couldn't find it. Maybe my version of
> Eagle is too old??

I am using the current version of Eagle (version 4).

I just fired up Eagle and checked.  Go to a board layout and run TOOLS >
DRC.  This brings up an applet window with 9 tabs.  The second tab from the
right is labeled MASKS.  In it is a parameter called LIMIT.  This can be
used to adjust the maximum size of vias that will be covered by solder mask.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads