Broadly, I would say that a good starting point
would be to estimate or measure the 'paths' (for
physical length and RF path loss) over which you
wish the various nodes to operate ... this will
guide you in your 'link budget' analysis and
help you in your selection of frequency band,
RF output power, receiver sensitivity and antenna
heights and gain ... this is irrespective of the
data or message 'protocol' (mesasge handling) to
be used ...

RF Jim

----- Original Message -----
From: "Jonathan Johnson" <jonathan@OUTEREDGE.NET>
To: <PICLIST@MITVMA.MIT.EDU>
Sent: Tuesday, October 22, 2002 7:26 PM
Subject: [EE] WIRELESS REPEATER NODE


> Has anybody on list had any experience with setting up a wireless repeater
> node for multipoint apps? can you offer any tips or pointers where to
start?
>
> Regards
>
> Jonathan
>
> --
> http://www.piclist.com#nomail Going offline? Don't AutoReply us!
> email listserv@mitvma.mit.edu with SET PICList DIGEST in the body
>
>

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body