Do this:

- Draw the borders of your rectangular hole on the enclosure
- Make holes with your drill with a small diameter following the borders
of the enclosure, but make the on the "inside" of the hole. Make the
holes as close as possible.
- Now, with a cutter, cut the remaining material between holes and
that=92s it, you have your rectangular hole!

Good Luk!

Mauricio Jancic
Janso Desarrollos
(54) 11 - 4544 - 5613
(54) 11 - 4542 - 3519
Republica Argentina



> -----Original Message-----
> From: pic microcontroller discussion list=20
> [mailto:PICLIST@MITVMA.MIT.EDU] On Behalf Of paul wood
> Sent: Mi=E9rcoles, 25 de Septiembre de 2002 02:04 p.m.
> To: PICLIST@MITVMA.MIT.EDU
> Subject: [OT]: how to make a rectangular hole on enclosure
>=20
>=20
> Hello,
>=20
> I want to make a small rectangular hole on a plastic
> enclosure so as to fit in a slide switch, but since it
> is not circular, I cannot use a drill. Is there any
> way or tools to make this hole easily?
>=20
> Paul
>=20
>=20
>=20
>=20
> __________________________________________________
> Do you Yahoo!?
> New DSL Internet Access from SBC & Yahoo!
> http://sbc.yahoo.com
>=20
> --
> http://www.piclist.com hint: The list server can filter out=20
> subtopics (like ads or off topics) for you. See=20
http://www.piclist.com/#topics

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics