On Wed, 18 Sep 2002, James Williams wrote:

*>No, you are wrong it does not have to be EPP compatible.  Only SPP which
*>is compatibility mode, nStrobe signal, nBusy and nAck signals for write.
*>You can also do nibble read.  The point is it DOES NOT HAVE TO BE A EPP
*>device.  As long as your device does the following:
*>1.  Responds to an nStrobe negative pulse.
*>2.  Bring nBusy high in response to step one.
*>3.  Finally pulse nAck and bring nBusy low.

Okay, I will try it out next time. But I see it as three pins on the
interface, wasted. There are only 13 of them so this is a significant
loss. I have made several parallel controlled devices in the past, that
cannot dispense with these three pins.

Peter

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads