Here - try one of these....what size do you need?
But really,
Depending upon the number of holes, one ot those push-pins (thumb tack) with
the large plastic hat shaped grips even spreads PTH's. If they're not
plated, just rough up the pin and it will work more like a rasp. If you can
cut a single flute into the side of the pin you'll actually have a simple
drill - a dremel with a thin cut-off wheel will accomplish this...

If you have 100 holes to do, forget it, suggest losing a day and buying more
drills.. Otherwise, you'll run out of fingers before pins.
The small swiss files work well also, if you have them.

Chris
>
> I can't find the drill bit I need.  Everything I have is far
> too big or far
> too small.  I need to drill standard size PCB holes (will fit an IDC
> header), and have already drilled small holes inside the
> pads, since I could
> find that bit.  Anyone know a way of widening those small
> holes with stuff
> comonly lying around an electronics shop?
>
> --Brendan
>

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body