I have a really nice hand-reamer that goes from about 0.8 to 4mm -
made by Hall in the UK "Micro drill-reamer", stocked by
http://rswww.com

On Wed, 28 Aug 2002 13:36:54 EDT, you wrote:

>In a message dated 08/28/2002 13:19:34 Eastern Daylight Time,
>bmoran@MILLENNIUM.CA writes:
>
>
>> I can't find the drill bit I need.  Everything I have is far too big =
or far
>> too small.  I need to drill standard size PCB holes (will fit an IDC
>> header), and have already drilled small holes inside the pads, since I=
 could
>> find that bit.  Anyone know a way of widening those small holes with =
stuff
>> comonly lying around an electronics shop?
>>
>
>For bmoran
>
>Do you have a set of Swiss files - stick one in a drill press and ream =
out
>your hole.  Also, True Value, Home Depot and ACE sell wire size steel =
drills.
>
>
>Sid Weaver - W4EKQ
>
>< < < <
>Remember - Fumpus tegit .

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body