In a message dated 08/28/2002 13:19:34 Eastern Daylight Time,
bmoran@MILLENNIUM.CA writes:


> I can't find the drill bit I need.  Everything I have is far too big or far
> too small.  I need to drill standard size PCB holes (will fit an IDC
> header), and have already drilled small holes inside the pads, since I could
> find that bit.  Anyone know a way of widening those small holes with stuff
> comonly lying around an electronics shop?
>

For bmoran

Do you have a set of Swiss files - stick one in a drill press and ream out
your hole.  Also, True Value, Home Depot and ACE sell wire size steel drills.


Sid Weaver - W4EKQ

< < < <
Remember - Fumpus tegit .

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body