Thanks to everyone for helping me out.  I like Matt's solution given below
and will give it a try.  Frankly, I'm not sure "how close" I need the
signals to match so I'll see if this works.

Regards,
Donovan



> Use a quad two input XOR (74HC86 or similar) gate package -- use two
> gates, connect your input signal to one input of each gate. Connect a
> logic '1' (+V) to the other pin of one gate and logic '0' (ground) to
> the other pin of the second gate.
>
> You now have an inverted signal on the output of gate with a logic '1'
> on the input and a non-inverted signal on the output of the gate with a
> logic '0' on the input.
>
> The delay will be the same (or very very close) for both signals. XOR
> gates make great switchable inverters, dirt cheap too! ;-)
>
> Matt Pobursky
> Maximum Performance Systems
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
>
>
>
>
>

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads