Here is something I have just never seen but need something to make this next =
project work.

We have a barrel type push button switch with LED inside, so there are 4 =
connectors on the end of the barrel, they stick straight out and are meant to =
be soldered to or have a spade type connector slide onto them.

What I want is a socket type connector so the switch will plug into the PCB at =
a right angle and no soldering or flying leads to connect, we are adding 8 =
switches so this will save much cost if it can be done.

I have contemplated small copper pieces bent 90 degrees and two of them side by =
side in a small opening in PCB similar to a 110AC wall plug but this would have =
implications at the wave solder station and be hard to deal with.

Any ideas people?

I could send a picture of the connector on end of switch to anyone wanting a =
better idea.

Richard.

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads