I have seen really good looking custom decals on people's elesctonics cases/enclosures. Even one-off's can look pretty professional with these. Where are they obtained? Can any corner printing shop do these, or do you ahve to special order them? Is there an outfit that can do custom silkscreens for this purpose? Obviously PC board mfrs do silkscreens for PC board art, which us one-off labs never mess around with. I wonder how they get them made? -- Lawrence Lile Senior Project Engineer Toastmaster, Inc. Division of Salton, Inc. 573-446-5661 voice 573-446-5676 fax "Peter L. Peres" Sent by: pic microcontroller discussion list 08/09/02 01:54 PM Please respond to pic microcontroller discussion list To: PICLIST@MITVMA.MIT.EDU cc: Subject: Re: [OT]: Leveling surface On Fri, 9 Aug 2002, Josh Koffman wrote: >Hi all. I have a few cases similar to: >http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=39196 >The surfaces are aluminum, but with a sort of textured surface. I would >like to put some stickers (decals) on these cases, but I am having >trouble getting things to stick to the non flat surface. Any ideas of >what I could do? I was thinking about getting some 5 minute epoxy, Silk screen or mask + paint gun (air brush) works fine here. Do not expect the result to look even. Use a large mask, large lettering etc. From a distance it looks great. >spreading a thin layer on the case to even out the bumps, then pressing >the sticker into the epoxy. It should work, but I'm worried I won't be >able to contain the epoxy, it will spread wider than the sticker, and >then look ugly. Any other ideas? Peter -- http://www.piclist.com hint: PICList Posts must start with ONE topic: [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.