At 06:41 PM 8/9/02 -0400, Derek Cowburn wrote: >Dwayne, >I tend to use the MPLAB assembler. Should I use the one from ME Labs? Try it and see. If you get an error message, go into PBP's setup options (or the MCS setup options - I don't remember which it is) and change to using the MELabs assembler (PM). I had a problem with this early on and was told that MPLAB will not accept multiple config statements whereas PM does. What little PBP code I write is done using Mecaniq's Micro Code Studio (MCS) - it works well and completely hides the details of dealing with the PBP compiler. Thus my hazy recollection. dwayne -- Dwayne Reid Trinity Electronics Systems Ltd Edmonton, AB, CANADA (780) 489-3199 voice (780) 487-6397 fax Celebrating 18 years of Engineering Innovation (1984 - 2002) .-. .-. .-. .-. .-. .-. .-. .-. .-. .- `-' `-' `-' `-' `-' `-' `-' `-' `-' Do NOT send unsolicited commercial email to this email address. This message neither grants consent to receive unsolicited commercial email nor is intended to solicit commercial email. -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu