When doing my last project I didnt have the ICD hooked up, so I would use
the PICSTART to store data to the EEPROM and then read it out to verify that
I had read correctly, and also wrote to it, then used the PICSTART to read
it out to verify it.

Now...I have this project using the ICD.  I thought I could do the same
thing, in that I would open up the EEPROM window, and be able to fill the
locations with a value.  If I then use the programmer interface it doesnt
seem to work.  Just thinking...I wonder (I dont have the setup in front of
me now) if filling the EEPROM and modifying the data...that actually doesn't
write out to the EEPROM?  So basic question is, how does one modify the
values in it using the ICD.  I think I might just be missing a step or two.

Also, the clock freq is diff for this project, but that should not affect
the read?  In other words, I did a cut n paste from the other project to
this one, and it doesnt seem to be working correctly yet...while it did work
fine in the other one.



_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads