> Got the code simulating right in MPLAB, anyone fancy checking
> the circuit I've got planned? :)  Would be very helpful to me,
> thanks.

I thought you had the RC oscillator wired upside down until I noticed that
you had the - rail at the top and the + rail at the bottom.  Argh!  Don't do
that.  You also managed to confuse yourself with this because you have MCLR
tied to Vss, which will keep the chip permanently in reset.

There are no LEDs "rated at 5V".  Perhaps you mean one with a built in
resistor.  Even so, I would wire up the LED between the + supply and the PIC
pin because the low side drivers are stronger than the high side drivers.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body