John, This is the closest I've found so far, and would be ideal if they are 0.5 Mode. Are they? (Specifically) the 60T gear. Thanks, -Neil. -----Original Message----- From: pic microcontroller discussion list [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of John Fletcher Sent: Thursday, July 04, 2002 1:17 AM To: PICLIST@MITVMA.MIT.EDU Subject: [OT]: Small plastic gear sources? Hi Neil, Have a look at my website (http://www.kanga.demon.co.uk) under Robotics. I might have what you need. Best regards, John In message , Pic Dude writes >Can anyone recommend good sources for low-cost plastic >gears? > >I specifically need a 0.5-mode gear with 60, 90, or 120 >teeth for the pet-feeder project, but the only ones I've >found are over US$10 each. A similar-sized standard part >is a buck or less. Not sure why the big difference, but >there's got to be a million other sources that may do >better. > >Cheers, >-Neil. > >-- >http://www.piclist.com hint: The list server can filter out subtopics >(like ads or off topics) for you. See http://www.piclist.com/#topics > > -- John Fletcher -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body