> Or even better glue a thermistor to the resistor and run the flash until
> the readout (ohms) is stable. Then disconnect the flash supply and connect
> a benchtop PSU across the R and set it until you obtain the exact same
> reading. ...

This will only measure the RMS current going into the flash, which will NOT
tell you the power going into the flash.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads