Had a look at the BIOS - no options for wake on power up unfortunately..

This sounds good though - thanks Brendan.  I was thinking I'd have to power
the pic from an external psu, but if I can grab power off the header then
that simplifies things.

> So, what you need to do is break the connection that that green wire
makes.
> A relay would work for that.  Also remember that the purple wire is a
source
> of +5V even when the power supply is "off" (when the green wire is
floating)
> so you can power your PIC control circuit from that.
>
> Hope that helps.
>
> Regards,
>
> Brendan
>
> ----- Original Message -----
> From: "Jim Main" <jim.main@MAINTECH.CO.UK>
> To: <PICLIST@mitvma.mit.edu>
> Sent: Wednesday, June 19, 2002 9:04 AM
> Subject: [EE]: Cycling power remotely on an ATX PC
>
>
> > I have an application at a remote site where I send data over a WAN to a
> PC,
> > which then talks to a PIC interface controlling various bits of
equipment.
> >
> > Since PC's occasionally crash, I've put in a telephone-operated switch
on
> > the power feed to the PC.
> >
> > Problem is, I've just realised that cycling the power in this way means
> the
> > PC won't boot up (since the front power button needs to be cycled after
a
> > mains reset).
> >
> > Any suggestions?
> >
> > I'm thinking maybe of another pic that delays a bit then closes a relay
> > contact across the power jumper on the motherboard....
> >
> > --
> > http://www.piclist.com#nomail Going offline? Don't AutoReply us!
> > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body
> >
> >
>
> --
> http://www.piclist.com#nomail Going offline? Don't AutoReply us!
> email listserv@mitvma.mit.edu with SET PICList DIGEST in the body
>
>
>

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body