----- Original Message -----
From: "Olin Lathrop" <olin_piclist@EMBEDINC.COM>
> If you want to make a single sided PC board yourself, try telling Eagle it
> is a double sided board but make the cost for routing in the top layer
very
> high and use lots of optimization passes.  If the number of top layer
traces
> is then pretty small, you could implement them as hand soldered jumpers.

on a related topic anyone know a good way to set up a specctra (7.1 I think)
autorouter to do a similar thing. This thing has more config options than
you would believe and I use it just often enough to ensure I've forgotten
everything by the next time I use it..... But it does seem to do a good job
of auto routing and I like the way it spreads tracks and mitres them....

Andy

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu