10x 4 help guys! it really help me!
where all of u got the manuals? i can't find any....:-(

Regards

Tal Bejerano
AMC - ISRAEL


-----Original Message-----
From: pic microcontroller discussion list [mailto:PICLIST@MITVMA.MIT.EDU]On
Behalf Of Stefano
Sent: Sunday, May 12, 2002 4:37 AM
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [PIC]: Eagle Auto route


before reducing the dimension of the traces, you might try to change the
directional organization of the routing. There are two menus (left up)
with TOP and BOTTOM preferred direction. CHoose the star * and see how
much it helps. Then start decreasing the number 50. Go to 30, 20 and below
in steps of one... DO not choose a parameter too small (5 or 8) otherwise
traces are too thin and close each other.

Stefano Curtarolo



> Use the Group tool to select all the traces in the board view, then  use
the
> Ripup tool, but RIGHT click the board, all the traces should revert to
> air-wires.  Also reroute with the Routing Grid set to 10 (I think the
default is
> 50, and that is usually too big).
> David
>
> Tal Bejerano - AMC wrote:
>
> > Hi All
> >
> > ok.. I have a complex schematic and I want to do auto route.
> > I start the auto route and the process begin
> > the final result are too many unrouted tracks..
> > my question is:
> > how I start a new auto route? playing with options/parameters don't give
any
> > better results
> > deleting the board and start new board auto route force me to place the
> > component in place again.
> > what  can I do to start auto route without all this mess?
> > what are the differences in the direction signs? "/ \ * . |"
> > if someone can explain in details I'll appreciate it.
> >
> > Regards
> >
> > Tal Bejerano
> > AMC - ISRAEL
> >
> > --
> > http://www.piclist.com hint: To leave the PICList
> > mailto:piclist-unsubscribe-request@mitvma.mit.edu
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
>
>

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads