At 11:11 AM 4/12/02 -0600, you wrote:
>I can think of a few possible solutions:
>
>1) Digikey, etc. has a large selection of connectors, including what you are
>looking for
>2) If you only need 1 set, buy a header/socket set with long solder tails
>and bend the tails to
>     the required 90 degrees.
>3) Mount a header on one board and a wired connector on the other, allowing
>you to
>     plug/unplug the boards.
>4) Headers on both boards, with adjoining cable, or
>5) Hardwire the two boards

Flat cable, stripped with 0.1" pitch. Very cheap if you buy enough of them
and quite tolerant of board misalignment. Be very careful of rigid arrangements
of boards and connectors, they can have reliability problems if there is
not enough mechanical "float" built in.

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com
9/11 United we Stand

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads