Hi all,
I am about to start playing with 16F628's after so far only using 16F84's.

I have a couple of initial questions:

1) I have a home made parallel port type programmer that I have been using
for the 16F84's will this be ok to use with the 16F628's (As I recall the
16F84 uses high voltage programming of the flash, will this fry my '628?)

2) I am intending to run it with a 20Mhz crystal. Should I be using the HS
or XT fuses?

Thanks very much,
James Fitzsimons

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads