> My dev board is just one of the Microengineering labs units, and I
soldered
> the RJ jack to it, wired the couple of wires to the PORTB connetions, so
> there isn't a header.  You can't just program the chip using the ICD can
> you?

You sure can!

>The debugger is loaded automatically to the target isnt it?

No, it isn't!

All you need to do is make sure the "Enable Debug Mode" checkbox is cleared
in the ICD options dialog.

Then after programming you should be able to disconnect the ICD from the
target and go.

One thing to watch out for: when using the ICD it will drive the MCLR line
appropriately. You should make sure that MCLR will be high on the target
with the ICD disconnected.

Bob Ammerman
RAm Systems

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu