My dev board is just one of the Microengineering labs units, and I soldered the RJ jack to it, wired the couple of wires to the PORTB connetions, so there isn't a header. You can't just program the chip using the ICD can you? The debugger is loaded automatically to the target isnt it? >From: "Rick C." >Reply-To: pic microcontroller discussion list >To: PICLIST@MITVMA.MIT.EDU >Subject: Re: [PIC]: ICD migration to target app problems >Date: Wed, 10 Apr 2002 18:28:11 -0400 > >Yes. That's all..that's right. Why aren't you programming it in the ICD >header and removing it from the header and plug it into the main board? >Rick > >Micro Eng wrote: > > > Debug mode disabled... > > > > There isnt anything in the code, besides the first NOP that needs to be > > there for ICD...right? It needs to be there for the jump for the ICD > > debugger code...I think > > > > _________________________________________________________________ > > MSN Photos is the easiest way to share and print your photos: > > http://photos.msn.com/support/worldwide.aspx > > > > -- > > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > >-- >http://www.piclist.com#nomail Going offline? Don't AutoReply us! >email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > _________________________________________________________________ Send and receive Hotmail on your mobile device: http://mobile.msn.com -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu