> Page 116, section 11.3 of the data sheet for the device you are using
> (DS30292)says:
>
> "The ADCON1, and TRIS registers control the operation of the A/D port
> pins. The port pins that are desired as analog inputs must have their
> corresponding TRIS bits set (input). If the TRIS bit is cleared
> (output), the digital output level (VOH or VOL) will be converted."

Yes, I read those notes and figured it was possible.  After a quick try (not
very thorough at all) I wasn't receiving the proper voltages on the pins.
MPLab simulator didn't set the pins when I steped through it.  ??

The line that puzzles me a bit is "will be converted" - does this mean if
the TRISA is set as output, the analog value will converted to a VOH or VOL
for the A/D converter, or does it mean what we both assumed?

Thanks.

Adam

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body