In the course of doing my first programming of a 16F877, I am seeing
an error message everytime I hit the program button. The error message
is: "Command [66] not echoed properly [FE]". In spite of the error
message, MPLAB indicates that the programming was successful.

Another message that I see when I hit the verify button is: "Command
[54] not echoed properly [FC]". Again, MPLAB indicates that the verify
was OK.

Are these known problems that I'm just seeing for the first time? Am I
perhaps missing something in my hex file or might I need an update for
my Picstart firmware? I'm currently running MPLAB 5.50 (firmware rev
2.30 in the programmer) which is the latest version that I've seen.


Regards, Bob

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads