Yes, this is the software I need!!! Friendly Regards Octavio Nogueira =================================================== nogueira@propic2.com ICQ# 19841898 ProPic tools - low cost PIC programmer and emulator http://www.propic2.com =================================================== ----- Original Message ----- From: "Lucas Thompson" To: Sent: Thursday, March 14, 2002 3:41 PM Subject: Re: [OT]: Monitor repairs ? > I used to work on Apple monitors a lot, mostly OEMed by Panasonic and Sony. > There was special elaborate software that communicated with the monitor and > was used to adjust the bright, sub-bright, geometry, etc. If you replaced > the main controller board in some of those monitors, you had to make sure > that you downloaded and backed up the monitor's configuration so that you > could re-upload it onto the new board and get the settings for the > individual tube, yoke, and flyback right - otherwise it was very very > difficult to adjust without signal generators and other special tools. > > It wouldn't suprise me if there was special software. > > Lucas > > > -----Original Message----- > > From: Andre Abelian [mailto:engelec@EARTHLINK.NET] > > Sent: Thursday, March 14, 2002 9:16 AM > > To: PICLIST@MITVMA.MIT.EDU > > Subject: Re: [OT]: Monitor repairs ? > > > > > > Octavio, > > > > The only software I can think of is the driver > > Which most likely you do not even need it because > > Inside of your monitor there is a EEPROM contains > > Driver information when you plug it in your windows will > > Detect and install it for you. Have you Played with > > buttons on front panel ? I repaired lots of monitors > > before you shouldn't have problem like this unless > > some one played with it. > > > > Andre Abelian > > > > > > -----Original Message----- > > From: pic microcontroller discussion list > > [mailto:PICLIST@MITVMA.MIT.EDU] On > > > > Hi Andre and others, I also have a problem with a > > Panasonic Panasync S17. > > I've changed the flyback transformer and now I can > > not get the width and pincushion adjust right. > > Someone told me I would need a special software > > from Panasonic to adjust it, I've been in contact > > with Panasonic but they were of no help. > > where can I get this software? > > > > Friendly Regards > > > > Octavio Nogueira > > =================================================== > > nogueira@propic2.com ICQ# 19841898 > > ProPic tools - low cost PIC programmer and emulator > > http://www.propic2.com > > =================================================== > > > > ----- Original Message ----- > > From: "Andre Abelian" > > To: > > Sent: Wednesday, March 13, 2002 2:07 PM > > Subject: Re: [OT]: Monitor repairs ? > > > > > > > Slan, > > > > > > Explain more about the problem > > > > > > Andre > > > > > > > > > -----Original Message----- > > > > > > I have a 19" LG 995SU monitor in front of me here and it has just > > > started to > > > go fuzzy in spots. And these spots move around! > > > It is out of warranty at this stage, the retailer just wants to > > replace > > > it - > > > i.e. buy a new one, and there are no repair services for this unit > > > within > > > easy reach. (I'd have to export to the UK for service!) > > > I did a websearch but came up with little info re this unit. > > > > > > Does anyone know of a site with fault/repair info for monitors. Any > > > pointers > > > at all would be appreciated. > > > > > > Slan > > > John > > > > > > -- > > > http://www.piclist.com hint: To leave the PICList > > > mailto:piclist-unsubscribe-request@mitvma.mit.edu > > > > > > -- > > > http://www.piclist.com hint: PICList Posts must start with > > ONE topic: > > > [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other > > [BUY]:,[AD]: ->Ads > > > > > > > > > > -- > > http://www.piclist.com hint: PICList Posts must start with ONE topic: > > [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads > > > > -- > > http://www.piclist.com hint: The list server can filter out subtopics > > (like ads or off topics) for you. See http://www.piclist.com/#topics > > > > > > -- > http://www.piclist.com hint: The list server can filter out subtopics > (like ads or off topics) for you. See http://www.piclist.com/#topics > > -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.