At 01:14 PM 12/03/2002 +0100, you wrote:
>... I asked for solution of my problem few days ago, but no answer and no
>solution jet. So I ask again!
>
>     I have problems with PORTB on F876. My project is temperature regulating
>with PT100 and 6x7seg display with CD4511 decoder and 6 PNP's for digits
>turning on and off. And that fork just fine. I also have 3 tasters (for
>seting up of critical temperature) connected on PORTB, pins 7, 6, and 5. And
>that is what don't work at all. For information, I tested everything in
>MPLABsim and there everythin is OK. But when I burn it in F876 and power ON,
>tasters just dont work. Sometimes they work unpredictable, sometimes not
>work in all, sometimes for a moment good but then microC hang...

Err, what's a "taster" in PIC lingo ?
Regards...

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu