... I asked for solution of my problem few days ago, but no answer and no
solution jet. So I ask again!

    I have problems with PORTB on F876. My project is temperature regulating
with PT100 and 6x7seg display with CD4511 decoder and 6 PNP's for digits
turning on and off. And that fork just fine. I also have 3 tasters (for
seting up of critical temperature) connected on PORTB, pins 7, 6, and 5. And
that is what don't work at all. For information, I tested everything in
MPLABsim and there everythin is OK. But when I burn it in F876 and power ON,
tasters just dont work. Sometimes they work unpredictable, sometimes not
work in all, sometimes for a moment good but then microC hang...

I check code for a milion times, bank switching, interrupt calling and
returning ...

I enable PULL_UPs on PORTB and checking for 0 on pins, turn off LVP, and
DEBUGGER, and work with P16PRO
programmer.

So, do anyone of you hav an idea what can be wrong, or where I make a
mistake! Maybe a P16pro just don't work OK, or...

I can posted a code here but it's a big cod...

thanx in advance
-------------------------------------------------
branek@eunet.yu
http://solair.eunet.yu/~branek
     ICQ - 15616778

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu