Aaron W. wrote:
>
> when i use the press and peel blue, i just use the tip of a hand iron, you
> can see the areas that are done because you can see the circuit pattern
> through the back of the press and peel blue sheets.
>
> i would like to make double sided PCBs, is there any sugestion on how to
> handle the plated through holes. has anyone used any of the gromets to make
> plated through holes? i think if i take an etched and drilled pcb and wave
> it through a solder pot, that might also do the trick of plated through
> holes.

Umm, do them like any 12 year old, drill
the board BEFORE etching, drill for parts
and the vias, then use the holes to align
your artwork or Dalo pen (you know you can
use almost any waterproof felt tip pen)
then after etching solder a piece of wire
(or leg cut-offs) as your through-hole vias.
Cheap, quick and darn reliable. :o)
-Roman

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body