Might I suggest a wire wrap DB25?  Teh wire wrap pins should be long
enough to spread them across the center channel on the breadboard, and
they'll felx enough to get it pluged in without too much work.  You can
use a small pair of needle nose pliers to offset the pins permanently.

Dale
--
"Curiosity is the very basis of education and if you tell me that
curiosity killed the cat, I say only the cat died nobly."
          - Arnold Edinborough


On Thu, 7 Mar 2002, James Ventura wrote:

> I just wanted to ask if it is possible to fit the pins of a 25 pin right angle D
> sub connector through the holes of a breadboard.  I just need to connect my
> prototype circuit to my computer's parallel port.

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu