I like to use a torch tip cleane to drill holes in my PCBs. It is about 1/2"
in dia. and about 4" long. You can buy them at most Welding stores, they
cost about 5-8 dollars. They have about 10 bits inside the drill casing. The
bits range in size from about .7mm to about 1/32".



Isaac D. Rose
Ohio University School of Electrical Engineering
|EE mailbox #576
Home:
230 W. State St.
Athens, Oh 45701
740-589-4793
email: Isaacdrose@ieee.org


_________________________________________________________________
Join the world s largest e-mail service with MSN Hotmail.
http://www.hotmail.com

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body